Philips L15-7io Ultrasound Probe

Pair the Philips L15-7io ultrasound probe with an IU22, IE33, HD11 or HD 15 system from the same brand. The catalogue lists this model as an aftermarket-compatible new unit or a repair support for the original transducer. Array type is ultrasound, frequency range is 7-15 MHz, and the SKU is Philips-L15-7io. Physical identification of the probe head and its connector comes before any order decision.

The connector pattern and the label marking of L15-7io tie directly to compatibility with the four listed systems. New aftermarket units and repair services are separate condition options, so the quotation must state which one applies. Shipping, packaging, inspection scope and delivery timing are settled case by case, shaped by the destination, the chosen condition and the requested service.

For further sourcing options in this catalogue, see the Specialty & Other Probes section, which also includes the Philips L12 Ultrasound Probe.

Frequently asked questions

What determines the shipping and packaging terms for this order?

The final terms depend on the destination country, the condition option you select, the courier route and whether the unit is new or a repair return. Each order is handled individually, so no shipping or packaging promise appears in this catalogue entry until your specific requirements are confirmed.

Does the L15-7io work with my IU22 or IE33 console?

The catalogue lists IU22, IE33, HD11 and HD 15 as compatible systems for this probe model. The frequency range is 7-15 MHz with an ultrasound array. You still need to match the connector on your console with the probe connector, because compatibility is confirmed for the exact model in the quotation.

How does this probe relate to the linked Philips L12 model?

The linked listing is the Philips L12 Ultrasound Probe, a separate model with a different frequency specification. This L15-7io sits in the Specialty & Other Probes category alongside the L12. The two are not interchangeable, so verify your system model and inspect the probe label before choosing either unit.

What should I look at on the connector and label before requesting a quote?

Check the probe label for L15-7io and the Philips imprint, then compare the connector pin layout with the socket on your IU22, IE33, HD11 or HD 15. The condition option, new aftermarket-compatible or repair service, affects whether a label exists on a serviced unit. Note what you observe for the quotation.