Philips C10-4EC Endocavity Ultrasound Probe

This C10-4EC endocavity transducer belongs to the Philips Epiq ultrasound family, and the catalogue maps it against the Epiq 5 and Epiq 7 host systems. It operates across a 4 to 10 MHz band, which defines its imaging envelope for endocavity work. The record lists a Compatible-New condition option, meaning a newly manufactured aftermarket-compatible unit, alongside a repair service for an original Philips C10-4EC transducer. Procurement teams should note that the probe is not made by Philips and is referenced for compatibility only.

Compatibility with the Epiq 5 and Epiq 7 is the anchor of this listing, but final suitability for a specific examination will depend on the host software revision and the connector condition on the unit you hold. Shipping, packaging, test scope and delivery timing are settled case by case after direct contact, since each consignment differs. The related C10-3V record offers a neighbouring endocavity option for buyers comparing within the same category.

For buyers comparing options within this category, the Endocavity Probes listing also contains the Philips C10-3V Endocavity Ultrasound Probe as a separate entry.

Frequently asked questions

What factors shape the shipping and packaging terms for this probe?

Each order is quoted individually. The final terms depend on your destination, the packaging specification you request for the aftermarket unit or repaired original, the carrier you prefer, and any verification or test work you want performed before dispatch. No timeline or packaging promise appears in the catalogue.

Will this C10-4EC handle my endocavity scans on an Epiq system?

The catalogue confirms compatibility with the Epiq 5 and Epiq 7. For a particular examination, your system software revision and the probe connector state matter. Raise those details when you enquire, and the quotation will confirm whether the listed condition suits your intended use.

Before you order: how do we check compatibility before we commit to purchase?

You confirm the exact host system model, its software version, and the physical connector on your ultrasound unit against the quotation. The seller then matches that information to this C10-4EC record and confirms whether the unit meets the stated compatibility for your specific Epiq configuration.

Which connector and label checks should our imaging engineer run on arrival?

Check the connector pins for bent or damaged contacts, and match the probe label’s model number and serial number against the delivery note. Also verify the label still shows the frequency band and array type. Report any mismatch immediately to Akicare.