Mindray P7-3s Phased Array Ultrasound Probe

This Mindray P7-3s phased array probe is paired with compatible Mindray ultrasound systems, serving as a direct aftermarket-compatible alternative to the original transducer. Its band spans 3 to 11 MHz, and the unit is supplied in a New Aftermarket-Compatible condition or as a professional a repair channel for the original Mindray P7-3s. When you receive a P7-3s, inspect the connector face for pin alignment and the strain relief boot for secure seating; the housing should carry the model imprint without abrasion. Every order is settled individually, so the exact inspection scope, availability, timing and shipping terms are put in writing ahead of any commitment.

This catalogue record describes the P7-3s as a phased array transducer, but it is not manufactured by or affiliated with Mindray; brand and model names appear solely for compatibility reference. For procurement teams and imaging engineers, the practical step is to request a quotation for the precise model, because the compatible system list, the test or inspection performed, and the delivery arrangements vary per unit. The related listing for the Mindray P7-3e phased array probe sits alongside this page, allowing a direct comparison of the two transducers before you finalise a sourcing decision.

For further sourcing options, compare this unit with the Phased Array Probes category and the Mindray P7-3e Phased Array Ultrasound Probe.

Frequently asked questions

On the commercial side: what warranty terms come with this P7-3s probe?

Warranty cover is agreed individually for each order, so no blanket period appears in this catalogue. Contact us with your intended use and we will confirm the cover in writing before you place any commitment.

Which condition options exist for the P7-3s and what do they mean?

You can choose New Aftermarket-Compatible, which is a replacement transducer built to match the original, or a Repair Service for your existing Mindray P7-3s. Both options are confirmed against your exact model at quotation stage.

Regarding this listing, how do I verify the connector and label on this phased array?

Check the connector pins for straightness and the shell for a snug fit into your system port. The label should show the P7-3s model and the 3 – 11 MHz frequency range, and you should photograph that label for your own record before installation.