Leapmed 120194 Reusable Biopsy Needle Guide for VINNO S1-8C

When you are sourcing or replacing a reusable biopsy needle guide for the VINNO S1-8C probe, the catalogue reference Leapmed 120194 gives you a specific supplier part to investigate. The source product title describes a stainless reusable biopsy guide, and the supplier reference ties the listing to a Leapmed product record. Your procurement team will need to move from this catalogue entry to a condition check and an enforced confirmation of the probe label before any order can proceed.

Inspection expectations for this unit centre on the stainless construction and the guide channel, since reusable guides accumulate wear at the needle entry point. Because this record does not carry a stated condition option, each offered unit is assessed individually at the point of enquiry. You should request close photographs of the guide surfaces, the locating pins and the locking mechanism, and you should ask how the guide has been stored between uses.

For additional sourcing options in the same catalogue category, review Biopsy Guides and the Leapmed 120193 Reusable Biopsy Needle Guide for VINNO G1-4P.

Frequently asked questions

How are shipping and packaging settled for this guide when I raise a purchase order?

Shipping method, packaging materials and any protective casing are settled per order, after you give the destination and the quantity. The catalogue does not state a fixed lead time or freight option, so the supplier will confirm those terms only once your exact request is defined.

Which condition options apply to this reusable guide, and what inspection do they entail?

This record lists no pre-set condition grades. For each unit, you will need to agree the inspection standard with the supplier, covering surface marks, channel alignment and the action of the clamp. Reconditioned units may require additional checks on the stainless finish.

What should I check on the connector and probe label before ordering this model?

Photograph the VINNO S1-8C probe label clearly, noting the model string and serial area. Confirm that the locating lugs match the physical probe nose shape, because the supplier reference alone does not confirm a fit across probe revisions. Also verify the single-use marking if any.

From the buyer’s side: how does this 120194 guide relate to the Leapmed 120193 Reusable Biopsy Needle Guide for VINNO G1-4P listed nearby?

The 120194 is specified for the VINNO S1-8C, while the 120193 is specified for the VINNO G1-4P. They are sibling catalogue records under the Leapmed supplier reference scheme, but each requires separate probe label verification. You cannot interchange them without confirming the physical fit on your particular probe.