Leapmed 120052 Reusable Biopsy Needle Guide for GE C2-7 / C2-7-VN / C2-7-D

When you are sourcing or replacing a reusable biopsy needle guide for a GE C2-7, C2-7-VN, or C2-7-D probe, the Leapmed 120052 is the supplier reference to place in your enquiry. This catalogue record is built from the supplier product record, so the guide type, compatible probe references and supplier identity are stated as provided rather than inferred from a photograph.

The illustration shown for this entry is representative and is not a photograph of the exact unit or a quoted guide. Before you submit an order, the complete probe label, bracket attachment geometry, guide channel, needle gauge range and requested reusable or disposable configuration all need to be confirmed in writing. Packaging, sterilisation or disinfection requirements, lead time and commercial terms are settled case by case after contact.

For a different probe family, the same Biopsy Guides category contains the Leapmed 120051 Reusable Biopsy Needle Guide for GE MTZ alongside this record.

Frequently asked questions

At order stage, what warranty terms apply to the 120052 reusable guide?

Warranty for the Leapmed 120052 is agreed individually for each order and is not promised in this catalogue. The final terms depend on the condition of the unit quoted, the quantity requested, any sterilisation evidence required and the delivery destination. Please raise an enquiry to receive written confirmation.

Is this guide suitable for biopsy procedures with the C2-7 probe?

The supplier record identifies the Leapmed 120052 as a reusable biopsy needle guide for the GE C2-7, C2-7-VN and C2-7-D probe references. Suitability for a specific biopsy procedure must be matched to the required needle gauge and probe configuration before you order.

On ordering: how does the 120052 differ from the 120051 guide?

The 120052 is listed under Biopsy Guides alongside the Leapmed 120051 Reusable Biopsy Needle Guide for GE MTZ. The two records carry different compatible probe references, so the guide that matches your probe must be identified from the full probe label and attachment geometry.