Chison P1 6-14 Linear Ultrasound Probe

This catalogue entry pairs the Chison P1 6-14 linear ultrasound probe with Chison ultrasound systems, where it serves as a direct linear-array transducer option. The unit is offered as Compatible-New, meaning it is a new aftermarket-compatible probe rather than a Chison-manufactured part. Physical identification centres on the P1 6-14 model mark, the linear array footprint, and the connector that mates with the host Chison system. For procurement and imaging engineers, the array type dictates the scan surface geometry, which is linear for this model.

Akicare supplies this aftermarket-compatible P1 6-14 and also provides a repair provision for the original Chison P1 6-14 transducer. Each repair or new-unit order carries its own verification and test protocol, agreed individually at quotation stage. Delivery timing, shipping method, and any warranty terms are likewise settled per order, not in this record. The probe is not manufactured by or affiliated with Chison; brand names appear solely for compatibility reference. Confirm the connector fit against the exact Chison system model before raising a purchase requisition.

For similar sourcing needs, review the Linear Array Probes category alongside the Chison L8M5-V Linear Ultrasound Probe.

Frequently asked questions

Before you order: what after-sales support can I expect for this P1 6-14 probe?

After-sales support is handled per individual order. For new units, you agree the verification and test protocol at quotation time. For repair work on an original Chison P1 6-14, the service includes quality inspection, but the exact checks and any return terms are confirmed before you commit.

On the commercial side: how do I verify that this probe will fit my Chison scanner?

Send your Chison system model and serial number with the RFQ. Akicare confirms connector compatibility and physical fit for that exact unit before you order. Since this is aftermarket-compatible, the host system model is the deciding factor for the interface, not just the P1 6-14 label.

What should I check on the probe label and connector for this model?

Locate the P1 6-14 model marking on the transducer housing and inspect the connector pins for bent or worn contacts. Also note the array face length, as linear probes vary in footprint. Share a readable close-up of the connector and label with your inquiry to speed up compatibility review.