Samsung PE2-4 Phased Array Ultrasound Probe

This catalogue entry covers the Samsung PE2-4 phased array probe, a unit designed for the WS80A system within the Samsung ultrasound equipment family. Physical identification of this transducer begins with its array type, phased array, and its frequency range of 2 to 4 MHz, as recorded for the Samsung-PE2-4 model. The unit is available as a new aftermarket-compatible item, meaning it is not manufactured by Samsung but is built to work with the WS80A.

For procurement and engineering teams, the condition options listed here are Compatible-New, and the same PE2-4 model also appears under a repair provision for the original Samsung transducer. This page is part of the Samsung / Medison Probes category. Any details on inspection scope, availability, timing, or shipping for this specific probe are resolved per order, not preset after direct contact, as they vary by unit and destination.

For other sourcing needs, see the Samsung / Medison Probes category, and note the separate entry for the Samsung PE2-4 (HM70A) Phased Array Ultrasound Probe if your system is that model.

Frequently asked questions

What is the lead time for this PE2-4 probe if we place an order today

The catalogue does not state fixed lead times. Delivery timing for this phased array probe is agreed at the point of order, depending on current availability and your location. You will receive a confirmed schedule only after we exchange details on the exact unit and delivery address.

On the commercial side: how do we confirm this probe works with our WS80A before purchase

Compatibility for the Samsung WS80A is recorded in the catalogue for this PE2-4 model. Before purchase, you should verify your specific system configuration, including software version and connector type, by sending your serial number and connector photograph. Your quotation will confirm the exact match.

Can you tell us what to check on the connector and label for this model

For this PE2-4, check the connector pins for straightness and the housing for cracks. The probe label should clearly show the model number Samsung-PE2-4 and the array type. You will receive a photograph of the actual unit label before dispatch, so you can verify the marking against your system.

On the commercial side: how does this listing differ from the Samsung PE2-4 (HM70A) Phased Array Ultrasound Probe

This listing covers the PE2-4 for the WS80A system. The related listing, Samsung PE2-4 (HM70A) Phased Array Ultrasound Probe, is a separate catalogue entry for the same probe model but intended for the HM70A system. Confirm your system model before requesting either unit.