Leapmed 120139 Reusable Biopsy Needle Guide for Siemens 4V1

This catalogue entry pairs the Leapmed 120139 reusable biopsy needle guide with the Siemens 4V1 probe. The source product title describes a stainless reusable biopsy guide for use with that probe. Supplier reference 120139 links the record to the Leapmed product page and places it under Biopsy Guides. A related catalogue entry covers a similar guide for the Siemens 14L5 probe, with supplier reference 120138.

For procurement, inspect each guide as a distinct unit. Condition grades and test scope are not applied uniformly across this catalogue; they are determined for the exact unit after contact. Ask how the offered guide has been inspected, what signs of wear or service history are known, and what testing, shipping and warranty terms would accompany that unit. Confirm the connector and label details before committing.

The Biopsy Guides section also carries the related listing for Leapmed 120138 Reusable Biopsy Needle Guide for Siemens 14L5, which suits a different Siemens probe.

Frequently asked questions

For your order: what after-sales support can I expect if I order this guide?

Support is settled case by case, not set in this catalogue. When you contact the team, ask whether technical assistance, replacement parts, returns, warranty cover and testing are included for the exact unit you intend to buy. Put the agreed scope in writing.

For your order: how does this guide relate to the other Leapmed biopsy guide listed alongside it?

This record is for the Siemens 4V1 probe, while the related listing is for a different Siemens probe. Supplier reference 120139 applies here, and the sibling listing uses reference 120138. Treat them as separate catalogue entries and confirm the probe model before ordering.

What condition choices are available for this reusable guide?

Condition is described for each unit rather than set across the catalogue. Ask the team how the specific guide has been graded, whether it shows wear, and whether it has been serviced or sterilised before delivery. No condition is implied until that unit is assessed.

Should I check the probe connector and label before sending an enquiry?

Yes, send a clear image of the Siemens probe label and connector so the team can compare against the supplier reference 120139. The guide is intended for the Siemens 4V1, so checking the probe identification helps avoid selecting the wrong catalogue entry.