Sonoscape 5P2 Phased Array Ultrasound Probe

When you are sourcing or replacing a Sonoscape 5P2 phased array probe for a Sonoscape S8 Exp or S9 system, the catalogue record gives you the reference points to identify the unit. This listing is for the Sonoscape 5P2, a phased array probe with a frequency reference of 2–9 MHz. The application references are cardiac and pediatric, so the probe is intended for those exam types.

Because condition grading and inspection expectations vary, you should treat this entry as a starting point for your request. The physical label, connector face and host-system configuration must be matched to the specific unit you intend to buy or sell. Each order is settled individually, so warranty cover, testing scope and delivery terms are agreed case by case after contact. Write to Akicare with your exact requirements and let the written quotation define the commercial terms.

For related sourcing needs, browse the Phased Array Probes category and compare the Sonoscape 5P1 Phased Array Ultrasound Probe with this 5P2 record.

Frequently asked questions

From the buyer’s side: what warranty applies to this 5P2 probe?

Warranty cover is handled on a per-order basis, not promised in this catalogue. The written quotation will state the exact warranty terms for the unit you request. Send your requirement and Akicare will confirm the applicable cover before you commit.

Will this probe work with my Sonoscape S8 Exp?

The catalogue records the compatible system references as Sonoscape S8 Exp and Sonoscape S9. Compatibility for your specific unit is confirmed against the physical label, connector and host-system configuration. Raise an enquiry with those details so Akicare can verify the match.

Is the 5P2 appropriate for cardiac scanning on children?

The application references for this probe are cardiac and pediatric. That means the Sonoscape 5P2 is recorded as suitable for those exam types. The specific patient population and clinical use remain your responsibility to assess against local practice.

Do you need photos of the connector and label before quoting?

Yes, for this model the supplier needs the full probe label and model number, plus the connector face and housing. The host-system manufacturer, model and software version also help. These details allow the order to be matched correctly to the unit.